You can be up and running, ready to take card payments in under 5 minutes with the plug & play capabilities of MyTime Pay and the Lane/7000 or 8000 pin-pad. Follow the few short steps below to connect your card terminal to WiFi.
- On the pin-pad press 2634 (the screen will change. If it does not re-try step 1 until you see the new screen)
- Press the F key (F key is below the number 7)
- You can use your finger for input on the screen OR utilize the included stylus.
- Select Tetra Admin
- Select 4-Configure Wi-Fi
- Select 2-Scan Networks
- Click/Select your wireless network after the scan is complete. Enter the password using the alphanumeric keypad. *The keypad uses T9 entry. Pressing each key more than once cycles from numbers to lower case letters to upper case letters*
- Once you have entered your password press the green circle/enter key to complete this setup.
- The device will confirm to connect, press the green button again on the pin-pad to confirm.
- Press the red X 4-5 times to return to the home screen.
You are now ready to take payments. The final step is to run a $00.01 test on your Lane/7000. If you get a 150 error when running a test transaction you have most likely entered the wrong WiFi password. You will need to follow steps 1-5 above, skip step 6 from above, and instead select 3-My Networks > select Delete All > try connecting again with the correct password*
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article